Description
These little 0.91″ displays don’t have mounting holes or anyway to hold them in position.
Our bezels will hold the display, allowing you to mount the display into your project box or panel.
This bezel hides an untidy cut-outs and does away with visible mounting screws. Making your project look more professional.
This bezel is NOT a low quality cheap 3D-print. It is a high-quality item machined from high-gloss black acrylic.
The OLED display
This is a commonly available 0.91″ 128×32 SSD1304 display with a 4-pin I2C interface. All displays are tested before shipping, so we know they work and fit the bezel. The bezels are made to fit the display we provide.
The OLED display colour varies with supply, but we usually ship a while OLED.
We test 100% of our displays before shipping, so you can buy with confidence.
The Bezel
This bezel is a custom-made part, machined from glossy black acrylic. The front of the bezel has a nice gloss black finish, and all other sides and edges have a machined finish. This is not a moulded part, and not 3D-printed.
The rear holding clip is made from ABS.
The OLED display is fixed into the rear of the bezel with the retaining clip. The bezel is fixed into your panel or enclosure with adhesive (not supplied).
Full instructions are included with the bezel.
Note that the bezel is not certified as moisture or dust proof.
Specifications
Overall size: nominal 47mm x 24.4mm
Material: Perspex/acrylic, and the retaining clip is made from ABS
Colour: The front of the bezel is gloss black. All other surfaces have a machined finish.
The OLED display colour varies with supply, but we usually ship a while OLED.
*** This is a machined item, so its measurements may vary slightly / approximate.
This item is shipped in a Large Letter Box for safety.
