Bezel for 1.3 inch 128x64 OLED display module with display
Bezel for 1.3 inch 128x64 OLED display module
1.3 inch 128x64 OLED display module in our bezel
1.3 inch 128x64 OLED display module for our bezel

Bezel for 1.3″ 128×64 SSH1106 OLED display

£8.46 – £14.46

This bezel makes your Arduino, Raspberry PI or other project look neater and more professional. It is specifically designed to accommodate a commonly available 1.3″ display.

This bezel has been specifically made to fit the commonly-used 1.3″ SSH1106 OLED Display Module that has a maximum size of PCB size of 35.1mm wide x 32.9mm tall (i.e. the total size of the display PCB). See the gallery images to see the specific OLED. This bezel will NOT fit any other display. Please carefully check the dimensions of your display before buying.

This product comprises either:
a) A bezel only, to fit a 1.3″ OLED display.
b) A bezel supplied with a tested 1.3″ OLED display.

 

Clear
SKU: BEOL13 Category:

Description

Do you want your Arduino or Raspberry Pi project to look more professional?
It is difficult to mount the 1.3″ OLED display in an enclosure without making an untidy hole with fixing screws. This bezel makes your project look more professional and tidy, and does away with ugly display mounting screws.
 
A High Quality Acrylic Part
This is a HIGH QUALITY part with a flat, very smooth, high-quality glossy surface, made from hard acrylic. This is NOT a low-quality 3D print (3D printed parts are typically made of soft, low-melting point plastic and have a rough, poor quality finish. Some 3D printer materials also do not accept adhesive making them difficult to use).
Our acrylic bezels will make your project look more-professional and give a quality touch to projects, and they are easy to use.
Description
The front of the bezel has a nice high-gloss black finish, and all other sides and edges have a machined finish. This is not a moulded part.
The corners are rounded for a softer look.
 
The OLED display (which is OPTIONALLY included in this item), is attached to the rear of the bezel with adhesive. The bezel (with the display) is then fixed into your panel or enclosure and fixed with adhesive.
NO adhesive is included with this bezel. 
Full instructions are included with the bezel
 
This bezel has been specifically made to fit a 1.3” 128×64 SSH1106 OLED display with overall PCB size of 35.1mm wide x 32.9mm tall. See the picture of the OLED used.
 
You may buy the bezel only from this listing, or buy the bezel with a matched display.
 
This bezel is designed to fit the stated display. Please carefully check the dimensions of your display before buying, or buy the bezel + display combination available in this listing.
Note that the bezel is not certified as moisture or dust proof.
 
Specifications
  • Overall bezel size: 45.2mm side x 43mm tall
  • Display module size: This bezel will accept the specified OLED displays whose PCB is up to 35.1mm wide x 32.9mm tall
  • Material: Perspex/acrylic
  • Colour: The front of the bezel is gloss black. The sides and rear of the bezel have a machined finish.
  • OLED interface: 2-pin I2C (IIC) plus VCC and GND. 
 
*** This is a custom-machined item, so its measurements may vary slightly.
 
The OLED module is OPTIONAL in this listing. Please make sure that, if you are using your own OLED, it has the correct dimensions to fit the bezel.
Adhesives are NOT included.

Related products